Filter
Top Products
800 Series Operator's Manual5Ć54
Use this function if you are connected to an LIS or data management system and
you want the 800 system to automatically accept QC results. When you use Auto
Accept with Auto Send, the 800 system accepts all QC samples and sends them to
the connected LIS or data management system. You can review the QC results at
the LIS or data management system and, if required, change the status to reject or
discard.
NOTE: Auto Send must be turned on to have results automatically sent to an LIS
or data management system.
On The system automatically accepts QC results and, when Auto Send is on,
sends the results to an LIS or data management system.
Off The operator accepts, rejects, or discards QC results at the end of analysis.
The default setting is Off.
1. Access the Global QC Settings screen from the Menu screen:
a. Select
5 Operating Setup and press Enter.
b. Select 1 QC Setup and press Enter.
c. Select
2 Global QC Settings and press Enter.
The Global QC Settings screen appears, as shown in Figure 5-32.
2. Move to the Auto Accept QC frame.
3. Select
On or Off and press Enter.
4. Press
Done.