Filter
Top Products
2Ć7
Operating the System
2. Press Analyze.
The system aspirates the sample.
3. When prompted, remove the sample device.
4. Type the required information in the Patient Information screen and then press
Done.
NOTE:ĄĂYou can scan the patient ID and the accession number fields if your
system uses the bar code option feature.
Results appear on the screen and are continuously updated until analysis is
complete. The system then displays the final results and prints the report.
Refer to Entering Patient Sample Data, page 2-27 if you need more
information to complete this screen.
5. The system performs a wash at the end of analysis and then returns to the
Ready screen. If the system continues to display the Results screen after the
wash finishes, press
Home to return to the Ready screen.
If the system determines that there is insufficient sample for routine analysis, a
message appears prompting you to position the sample manually. Refer to
Analyzing Microsamples, page 2-11, if you require additional information to move
the sample manually.
To interrupt sample analysis at any time, press Cancel. The system stops analysis
and performs a wash. The Ready screen appears when the wash finishes.
If you do not remove the syringe within 5 minutes of the screen prompt, the system
completes analysis and performs a wash. When you remove the syringe, the Patient
Information screen appears. Complete the screen as required.
Procedural
Notes