Filter
Top Products
System Administration 5Ć13
2. Select the parameters.
a. Move to the frame that contains the appropriate parameter.
b. Select the parameter that you want and press
Enter.
c. Repeat steps a and b for each parameter you want to change.
d. Press
Next Screen to access the second screen of parameters.
e. Repeat steps a and b for each parameter you want to change.
f. Press
Next Screen again to access the final screen of parameters.
g. Repeat steps a and b for each parameter you want to change.
3. Press
Done.
4. You can define another setup function or press
Exit Menu to return to the
Ready screen.
When you select a measured parameter to be on, you activate a sensor. Perform a
two-point calibration before you analyze a sample.
Use this procedure to select the measurement units that the system displays for each
parameter. Table 5-4 lists the default and optional measurement units that you can
select for the base models and for the base models with a CO-ox module.
pCO
2
, pO
2
mmHg kPa 840, 850, 860
O
2
CT, BO
2
mL/dL mL/L, mmol/L 840, 850, 860
(Continued)