Filter
Top Products
Use this procedure when you want to measure specific parameters for a single
patient sample. After the sample is analyzed, the system restores the default panel
for your system. Different panels are available for each system.
1. Press
Change Parameters.
The Parameter Panels menu appears, as shown in Figure 2-16.
2. Select a parameter.
one of the panels displayed select the parameter panel and press Enter. Custom
panels are listed as Panels 1–5 and are defined during
system setup by the system administrator or authorized
personnel.
specific parameters to
analyze
a. Press Select Parameters. The Select Parameters
screen appears.
b. Select the parameters you want and press
Done to
return to the Ready screen.
3. Insert the sample device into the sample port.
4. Press
Analyze.
After the next sample is analyzed, the default panel is restored.
If you select Previous Screen, the system returns to the Ready screen and restores
the default panel.