Filter
Top Products
Issue 4 September 1995 E-1
E
Functional Differences for G2 and G3
Call Vectoring and EAS
Introduction
This appendix provides the Call Vectoring functional differences between the
Generic 2 and Generic 3 switches. This information should prove helpful to
system administrators who administer networks that utilize both switches.
The appendix is organized into three sections. The first section indicates
differences between the Call Vectoring commands common to both the Generic
2 and Generic 3 switches. The second section consists of a table that indicates
general Generic 2 and Generic 3 differences within Call Vectoring. Finally, the
third section indicates differences between the two switches in defining and/or
interpreting split flows.
NOTE:
Call Prompting is not supported on G2.
Differences in Command Function
The following sections indicate the differences between the Generic 2 and
Generic 3 switch versions of the Call Vectoring commands. The commands
discussed include the following:
■
queue-to main split
■
check-backup split
■
goto step
■
goto vector
■
route-to number