Filter
Top Products
Tutorial
2-4 Issue 4 September 1995
The following list summarizes how you can enter a vector on-line via Basic
Screen Administration. For complete details on this process, consult
DEFINITY
Communications System Generic 3 Version 4 Implementation,
555-230-655
or
DEFINITY Communications System Generic 3 V2/V3 Implementation,
555-230-653.
1. Access the Call Vector Form by executing the “change vector x”
command, where
x
is a number between 1 and 256 [G3i], 1 and 48 [G3s
PBP, G3vs PBP], or 1 and 512 [G3r]. Use the “change vector” command
either to change an existing vector, or to create a new vector.
If you are not certain of the number or name of a vector, enter the “list
vector” command to view a complete list of all vectors that have been
administered for your system.
2. Assign a name to your vector by completing the blank next to Name. The
vector name can contain up to 15 alphanumeric characters.
NOTE:
The vector number, which appears next to Number, is automatically
assigned by the system.
3. Look at the next fields and note where a
y (yes)
appears. These fields
indicate the Call Vectoring features and corresponding commands you
can use. (The Call Vectoring features are optioned from the Customer
Options Screen.) On the other hand, if an
n
appears in one of these fields,
you cannot use the corresponding feature. A y in one of the fields
indicates the following.
Basic You can use the Basic Call Vectoring commands. See Chapter
4, "Basic Call Vectoring".
EAS Expert Agent Selection is enabled. See Chapter 10, "Expert
Agent Selection".
G3V4
Enhanced
You can use the G3V4 Enhanced Vector Routing commands
and features. See Appendix L, "V4 Feature Availability" for an
explanation of which features are included with G3V4
Enhanced Vector Routing.
ANI/II-Digits You can use the ANI and II-Digits Vector Routing commands.
See Chapter 7, "ANI and II-Digits Routing". ANI/II-Digits Routing
requires G3V4 Enhanced Vector Routing.
ASAI Routing You can use the Adjunct Routing command. See Chapter 9,
"Adjunct Routing".
Prompting You can use the Call Prompting commands. See Chapter 5,
"Call Prompting".
LAI Look-Ahead Interflow is enabled. See Chapter 8, "Look-Ahead
Interflow".
G3V4 Adv
Route
You can use the G3V4 Advanced Vector Routing commands.
See Chapter 6, "Advanced Vector Routing".