Filter
Top Products
8XC196NP, 80C196NU USER’S MANUAL
C-36
PTSSEL
PTSSEL
Address:
Reset State:
0004H
0000H
The PTS select (PTSSEL) register selects either a PTS microcode routine or a standard interrupt
service routine for each interrupt request. Setting a bit selects a PTS microcode routine; clearing a bit
selects a standard interrupt service routine. When PTSCOUNT reaches zero, hardware clears the
corresponding PTSSEL bit. The PTSSEL bit must be set manually to re-enable the PTS channel.
15 8
— EXTINT3 EXTINT2 OVR2_3 OVR0_1 EPA3 EPA2 EPA1
7 0
EPA0 RI TI EXTINT1 EXTINT0 — OVRTM2 OVRTM1
Bit
Number
Function
15, 2 Reserved; for compatibility with future devices, write zero to this bit.
14:3
1:0
Setting a bit causes the corresponding interrupt to be handled by a PTS microcode
routine.
The PTS interrupt vector locations are as follows:
Bit Mnemonic Interrupt PTS Vector
EXTINT3 EXTINT3 pin FF205CH
EXTINT2 EXTINT2 pin FF205AH
OVR2_3
†
EPA Capture Channel 2 or 3 Overrun FF2058H
OVR0_1
†
EPA Capture Channel 0 or 1 Overrun FF2056H
EPA3 EPA Capture/Compare Channel 3 FF2054H
EPA2 EPA Capture/Compare Channel 2 FF2052H
EPA1 EPA Capture/Compare Channel 1 FF2050H
EPA0 EPA Capture/Compare Channel 0 FF204EH
RI SIO Receive FF204CH
TI SIO Transmit FF204AH
EXTINT1 EXTINT1 pin FF2048H
EXTINT0 EXTINT0 pin FF2046H
OVRTM2 Timer 2 Overflow/ Underflow FF2042H
OVRTM1 Timer 1 Overflow/ Underflow FF2040H
†
PTS service is not recommended because the PTS cannot determine the source of
shared interrupts.