Filter
Top Products
Polycom, Inc. 364
Alert 4013
MCU <mcu> is connected with no port capacity.
The specified MCU has no ports available for call traffic.
This could indicate that the specified MCU is at capacity, or possibly a network problem. This alert appears
as soon as the port capacity of this MCU becomes 0, and is automatically cleared after two minutes.
Click the link to go to the Network > MCU > MCUs page to begin troubleshooting.
See also:
Alerts on page 342
Alert 4014
MCU <mcu> video port capacity changed from <oldcapacity> to <newcapacity>.
The video port capacity of the specified MCU has changed.
This could indicate a license change, video / voice port configuration change, or hardware change for the
MCU (perhaps a media card has been removed or added). This alert appears as soon as the video port
capacity of this MCU becomes 0, and is automatically cleared after two minutes.
Click the link to go to the Network > MCU > MCUs page.
See also:
Alerts on page 342
Alert 4015
MCU <mcu> voice port capacity changed from <oldcapacity> to <newcapacity>.
The voice port capacity of the specified MCU has changed.
This could indicate a license change, video / voice port configuration change, or hardware change for the
MCU (perhaps a media card has been added or removed). This alert appears as soon as the voice port
capacity of this MCU becomes 0, and is automatically cleared after two minutes.
Click the link to go to the Network > MCU > MCUs page.
See also:
Alerts on page 342
Alert 5001
<Model> ITP system attempting to register with ID <H.323 ID or SIP user name> is
improperly configured.
A device that identifies itself as an ITP (Immersive Telepresence) system has registered with the Call Server,
but the H.323 ID or SIP user name of the device doesn't specify its endpoint number or the number of
endpoints in the ITP system, as it should.