Filter
Top Products
Site Topology
Polycom, Inc. 293
See also:
About Site Topology on page 278
Site Links on page 291
Site Topology Configuration Procedures on page 299
Site-to-Site Exclusions
The Site-to-Site Exclusions page contains a list of the site-to-site connections that the site topology
doesn’t permit a call or session to use.
If the system is integrated with a Polycom RealPresence Resource Manager or CMA system, it receives this
information from that system, and this page is read-only. If not, you can define exclusions.
The commands in the Actions list let you add a site-to-site exclusion and delete existing exclusions.
The following table describes the fields in the list.
See also:
About Site Topology on page 278
Add Site-to-Site Exclusion Wizard on page 293
Site Topology Configuration Procedures on page 299
Add Site-to-Site Exclusion Wizard
Lets you define a new site-to-site exclusion in the Polycom RealPresence DMA system’s site topology.
To add a site-to-site exclusion
1 Go to Network > Site Topology > Site-to-Site Exclusions.
Field Description
Name A meaningful name for the link (up to 128 characters).
Description A brief description of the link (up to 200 characters).
From site The originating site of the link (view only).
To site The destination site of the link (view only).
Max bandwidth (Mbps) The total bandwidth limit for voice and video calls, which you set at the
gateway or router.
Max bit rate (kbps) The per-call bit rate limit for voice and video calls, which you set at the
gateway or router.
Column Description
From Site Name of one of the two sites connected by the excluded link.
To Site Name of the other site.