Filter
Top Products
Conference Manager Configuration
Polycom, Inc. 212
Content protocol Content channel protocol options:
• Use H.263.
• Use H.264 if available, otherwise use H.263.
• Use H.264 cascade and SVC optimized.
• Use H.264 HD.
Content resolution Specifies the resolution of the content channel for the conference and
cascade link.
Available only when Content protocol is set to H.264 cascade and SVC
optimized.
H.264 high profile Enables the H.264 High Profile set of capabilities for the content channel,
which enables additional compression efficiency and allows for higher
resolutions to use the same bandwidth.
Send content to legacy
endpoints (MPM+ and
MPMx only)
Enables endpoints that don’t support H.239 to receive the Content channel
over the video (People) channel.
Available only on MCUs with MPM+ and MPMx cards. Not available if Video
switching or Same layout is selected, or if Telepresence mode is Yes.
RMX Video Settings
Presentation mode Enables a conference to change to lecture mode when the current speaker
speaks for 30 seconds. When another participant starts talking, it returns to
the previous video layout.
Not available if Video switching or Same layout is selected, or if
Telepresence mode is Yes.
Same layout Forces the selected layout on all participants. Personal selection of the video
layout is disabled.
Not available if Presentation mode or Video switching is selected, or if
Telepresence mode is Yes.
Lecturer view switching When in lecture mode, enables the lecturer’s view to automatically switch
among participants (if the number exceeds the number of windows in the
layout) while the lecturer is talking.
Not available if Same layout is selected or Telepresence mode is Yes.
Auto layout Lets the system select the video layout based on the number of participants in
conference. Clear the check box to select a specific layout (below).
Not available if Video switching is selected or Telepresence mode is Yes.
Layout With Auto layout deselected, this opens the Select Layout dialog box, where
you can select the number and arrangement of video frames. Once a layout is
chosen, a small representation of it appears here. See Select Layout Dialog
Box on page 216.
Not available if Video switching is selected.
Field Description