Filter
Top Products
MCU Management
Polycom, Inc. 133
See also:
MCUs on page 124
MCU Procedures on page 139
Add Session Profile Dialog Box on page 138
Edit Session Profile Dialog Box on page 138
Edit MCU Dialog Box
Lets you edit an MCU. If you intend to edit the login information for the MCU (Management IP, Admin ID,
or Password), you must first stop using the MCU (terminating existing calls and conferences) or busy it out
and wait for existing calls and conferences to end.
Gateway Profiles
Copy from entry for ISDN gateway Lets you copy the delimiter and session profiles from another ISDN gateway
instead of entering them below.
This is especially useful for MGC devices because each ISDN network card
must be registered separately, but all cards support the same gateway
configuration.
Dial string delimiter The dial string delimiter used to separate the session profile prefix from the
ISDN E.164 number.
Session Profile table Lists the defined session profile prefixes. A session profile prefix is a numeric
dial string prefix that specifies a bit rate for the call and which protocols it
supports.
Click Add to add a session profile. Click Edit or Delete to change or delete
the selected profile. You can’t change or delete session profiles that the
MCU/gateway registered with, only those that you added.
Media IP Addresses
Add new media IP address If you specify the login information for the MCU, the system can get media
addresses from the MCU. If not, enter an IP address for media streams and
click Add to add it the list below.
Media IP addresses List of media addresses for the MCU.
Click Remove to delete the selected address from the list.
Postliminary A postliminary is an executable script, written in the Javascript language, that
defines dial transformations to be applied before routing the call to the
MCU/gateway.
Enabled Lets you turn a postliminary on or off without deleting it.
Script Type (or paste) the postliminary script you want to apply. Then click Debug
this script to open the Script Debugging Dialog Box for
Preliminaries/Postliminaries and test the script with various variables.
Field Description