Filter
Top Products
Configuration and Use Manual 85
Pressure Compensation and External Temperature Compensation
Measurement Performance DefaultsTroubleshootingCompensation
Figure 9-5 External temperature compensation – PROFIBUS host with the EDD
Figure 9-6 External temperature compensation – PROFIBUS bus parameters
Set up output module
(2)
Enter External
Temperature Input
Enable External Temp
for API or ED
Yes
MMI Coriolis Flow >
Temperature >
MMI Coriolis Flow >
Temperature >
External Temperature
Transfer
Done
Use static
temp value?
Transfer
No
Check Temperature unit
(1)
Transfer
(1) Temperature measurement unit must be
configured to match temperature unit used
by external device or static temperature
value. See Section 6.3.
(2) See Section 9.4.
Enable
Set temperature unit
Block: Calibration (Slot 2)
(1)
Index 34
Block: Measurement (Slot 1)
(1)
Index 7
(2)
Yes
Use static
temp value?
No
Set up output
module
(3)
Block: Calibration (Slot 2)
Index 35
Set static value
(1) See Tables D-3 and D-2 for more information about the bus parameters.
(2) Temperature measurement unit must be configured to match temperature unit used by external device or static temperature
value. See Section 6.3.
(3) See Section 9.4.