Filter
Top Products
Configuration and Use Manual 171
PROFIBUS Bus Parameters
Menus Display CodesBus ParametersDiagrams
11 SNS_StatusWords2 B_ENUM D (20 Hz) R • 0x0001 = Not Used
• 0x0002 = Not Used
• 0x0004 = Not Used
• 0x0008 = Not Used
• 0x0010 = Density out of range
• 0x0020 = Drive out of range
• 0x0040 = PIC\Daughterboard
communications failure
• 0x0080 = Not Used
• 0x0100 = Non-volatile memory error (CP)
• 0x0200 = RAM error (CP)
• 0x0400 = Sensor failure
• 0x0800 = Temperature out of range
• 0x1000 = Input out of range
• 0x2000 = Not used
• 0x4000 = Transmitter not characterized
• 0x8000 = Not Used
12 SNS_StatusWords3 B_ENUM D (20 Hz) R • 0x0001 = Not Used
• 0x0002 = Power reset
• 0x0004 = Transmitter initializing
• 0x0008 = Not Used
• 0x0010 = Not Used
• 0x0020 = Not Used
• 0x0040 = Not Used
• 0x0080 = Not Used
• 0x0100 = Calibration failed
• 0x0200 = Calibration failed: Low
• 0x0400 = Calibration failed: High
• 0x0800 = Calibration failed: Noisy
• 0x1000 = Transmitter failed
• 0x2000 = Data loss
• 0x4000 = Calibration in progress
• 0x8000 = Slug flow
13 SNS_StatusWords4 B_ENUM D (20 Hz) R • 0x0001 = API: Temperature out of range
• 0x0002 = API: Density out of range
• 0x0004 = Line RTD out of range
• 0x0008 = Meter RTD out of range
• 0x0010 = Reverse flow
• 0x0020 = Factory data error
• 0x0040 = ED: bad curve
• 0x0080 = LMV override
• 0x0100 = ED: Extrapolation error
• 0x0200 = Need calibration factor
• 0x0400 = Not Used
• 0x0800 = Not Used
• 0x1000= Transmitter not characterized
• 0x2000 = Non-volatile memory error (CP)
• 0x4000 = Non-volatile memory error (CP)
• 0x8000 = Non-volatile memory error (CP)
Table D-4 Diagnostic block (Slot 3) continued
Index Name
Data
type
Memory
class Access Definition/Code/Comments