Filter
Top Products
Configuration and Use Manual 67
Optional Configuration
Required Configuration Optional ConfigurationUsing the TransmitterUsing a PROFIBUS Host Required Configuration Optional ConfigurationUsing the TransmitterUsing a PROFIBUS Host Required Configuration Optional ConfigurationUsing the TransmitterUsing a PROFIBUS Host Required Configuration Optional ConfigurationUsing the TransmitterUsing a PROFIBUS Host
8.9.4 LCD panel backlight
The backlight of the LCD panel on the display can be turned on or off. To turn the backlight on or off:
• Using ProLink II, see Figure C-3.
• Using the display, see Figure C-15.
• Using a PROFIBUS host with the EDD, see Figure C-10.
• Using PROFIBUS bus parameters, use the Local Display block (see Table D-6), Index 13.
In addition, ProLink II, the EDD, and the bus parameters allow you to control the intensity of the
backlight. You can specify any value between
0 and 63; the higher the value, the brighter the
backlight. To control the intensity of the backlight:
• Using ProLink II, see Figure C-3.
• Using a PROFIBUS host with the EDD, see Figure C-10.
• Using PROFIBUS bus parameters, use the Local Display block (see Table D-6), Index 32.
8.9.5 Display functions
Table 8-10 lists the display functions and describes their behavior when enabled (shown) or disabled
(hidden).
To configure display functions:
• Using ProLink II, see Figure C-3.
• Using a PROFIBUS host with the EDD, see Figure C-10.
• Using PROFIBUS bus parameters, use the Local Display block (see Table D-6), Indices 4–12.
• Using the display, see Figure C-15.
Table 8-10 Display functions
Parameter Enabled (shown) Disabled (hidden)
Totalizer start/stop Operators can start or stop totalizers using the
display.
Operators cannot start or stop totalizers using
the display.
Totalizer reset Operators can reset the mass and volume
totalizers using the display.
Operators cannot reset the mass and volume
totalizers using the display.
Auto scroll
(1)
(1) If enabled, you may want to configure Scroll Rate.
The display automatically scrolls through each
process variable at a configurable rate.
Operators must
Scroll to view process
variables.
Off-line menu Operators can access the off-line menu (zero,
simulation, and configuration).
Operators cannot access the off-line menu.
Off-line password
(2)
(2) If enabled, the off-line password must also be configured.
Operators must use a password to access the
off-line menu.
Operators can access the off-line menu
without a password.
Alarm menu Operators can access the alarm menu
(viewing and acknowledging alarms).
Operators cannot access the alarm menu.
Acknowledge all
alarms
Operators are able to acknowledge all current
alarms at once.
Operators must acknowledge alarms
individually.