Filter
Top Products
52 Micro Motion
®
Model 2400S Transmitters for PROFIBUS-DP
Optional Configuration
8.2 Configuring volume flow measurement for gas
Two types of volume flow measurement are available:
• Liquid volume (the default)
•Gas standard volume
Only one type of volume flow measurement can be performed at a time (i.e., if liquid volume flow
measurement is enabled, gas standard volume flow measurement is disabled, and vice versa).
Different sets of volume flow measurement units are available, depending on which type of volume
flow measurement is enabled (see Tables 6-3 and 6-4). If you want to use a gas volume flow unit,
additional configuration is required.
Note: If you will use the petroleum measurement application or the enhanced density application,
liquid volume flow measurement is required.
Digital communication
settings
PROFIBUS node
address
✓
(3)
✓
(4)
8.10.1
IrDA port usage ✓✓ ✓8.10.2
Modbus address ✓✓8.10.3
Modbus ASCII support ✓✓8.10.4
Floating-point byte
order
✓ 8.10.5
Additional
communications
response delay
✓ 8.10.6
Digital communications
fault action
✓✓ 8.10.7
Fault timeout ✓✓ 8.10.8
Device settings ✓✓
(5)
8.11
I&M functions ✓ 8.12
Sensor parameters ✓✓ 8.13
Petroleum
measurement
application
✓✓ 8.14
Enhanced density
application
✓✓ 8.15
(1) Via either the EDD or PROFIBUS bus parameters.
(2) These parameters apply only to transmitters with a display.
(3) Via a Set Slave Address telegram.
(4) Via the address witches on the face of the transmitter.
(5) Via PROFIBUS bus parameters only.
Table 8-1 Configuration map continued
Method
Topic Subtopic ProLink II PROFIBUS host
(1)
Display Section