Filter
Top Products
66 Micro Motion
®
Model 2400S Transmitters for PROFIBUS-DP
Optional Configuration
To set the display language:
• Using ProLink II, see Figure C-3.
• Using the display, see Figure C-15.
• Using a PROFIBUS host with the EDD, see Figure C-10.
• Using PROFIBUS bus parameters, use the Local Display block (see Table D-6), Index 33.
8.9.3 Display variables and display precision
The display can scroll through up to 15 process variables in any order. You can configure the process
variables to be displayed and the order in which they should appear. Additionally, you can configure
display precision for each display variable. Display precision controls the number of digits to the right
of the decimal place. Precision can be set to any value between
0 and 5.
To configure display variables or display precision:
• Using ProLink II, see Figure C-3.
• Using a PROFIBUS host with the EDD, see Figure C-10.
• Using PROFIBUS bus parameters, use the Local Display block (see Table D-6):
- Use Indices 16–30 to specify the display variables.
- Use Indices 14 and 15 to specify display precision.
Note: This functionality cannot be configured via the display menus.
Table 8-9 shows an example of a display variable configuration. Notice that you can repeat variables,
and you can also specify None for any display variable except Display Variable 1. For information on
how the display variables will appear on the display, see Appendix E.
Table 8-9 Example of a display variable configuration
Display variable Process variable
Display variable 1
(1)
(1) Display Variable 1 cannot be set to None.
Mass flow
Display variable 2 Mass totalizer
Display variable 3 Volume flow
Display variable 4 Volume totalizer
Display variable 5 Density
Display variable 6 Temperature
Display variable 7 External temperature
Display variable 8 External pressure
Display variable 9 Mass flow
Display variable 10 None
Display variable 11 None
Display variable 12 None
Display variable 13 None
Display variable 14 None
Display variable 15 None