Filter
Top Products
Configuration and Use Manual 27
Required Transmitter Configuration
Required Configuration Optional ConfigurationUsing the TransmitterUsing a PROFIBUS Host
When configuring the flow calibration factor:
• Using ProLink II, enter the concatenated 10-character string exactly as shown, including the
decimal points. For example, using the Flow Cal value from Figure 6-1, enter
19.0005.13.
• Using other methods, you may be required to enter the concatenated value, or you may be
required to enter the two factors separately, i.e., enter a 6-character string and a 4-character
string. Include the decimal point in both strings. For example, using the Flow Cal value from
Figure 6-1:
-Enter
19.000 for the flow calibration factor.
-Enter
5.13 for the temperature coefficient for flow.
6.2.3 How to characterize
To characterize the flowmeter:
1. See the menu flowcharts in Figure 6-2.
2. Ensure that the correct sensor type is configured.
3. Set required parameters, as listed in Table 6-1.