Filter
Top Products
Configuration and Use Manual 159
Menu Flowcharts – Model 2400S DP Transmitters
Menus Display CodesBus ParametersDiagrams
Figure C-11 EDD – Configuration menu: API setup and ED setup
> Configuration
...
>> API setup parameters
(1)
API reference temperature
API thermal expansion coefficient
API2540 CTL table type
>> ED setup data
(2)
>>> ED global configuration
Active calculation curve
Derived variable
Lock/unlock ED curves
Reset all curve information
>>> ED curve specific config
Curve configured
Curve n name
Curve n long name
Curve n reference temperature
Curve n water reference temperature
Curve n water reference density
Curve n trim slope
Curve n trim offset
>>>> ED extrapolation
Curve n alarm limit
Enable density low
Enable density high
Enable temperature low
Enable temperature high
>>>> ED concentration
Curve n concentration units
>>> ED curve data
Curve temperature isotherm index (X-axis)
Curve concentration index (Y-axis)
Curve n (6*5) temp isotherm X Value (X-axis)
Curve n (6*5) density @ temp isotherm X, concentration Y
Curve n (6*5) coeff @ temp isotherm X, concentration Y
Curve n (6*5) concentration Y value (label for Y-axis)
Curve n (5*1) density @ concentration Y (at ref. temp.)
Curve n (5*1) coeff @ concentration Y (at ref. temp.)
Curve n (5*1) concentration Y value (Y-axis)
>>>> Curve fit results
Curve n fit results
Curve n curve fit expected accuracy
>>>> Maximum curve fit order
Maximum fit order for 5*5 curve
MMI Coriolis Flow DP >
MMI Coriolis Flow >
Configuration Parameters
Flow
Temperature
Density
Pressure
Discrete event parameters
Discrete event action code and
assignment
Alarm
Device
Sensor
Sensor limits
Display
Offline diagnostic info
API setup parameters
(1)
ED setup data
(2)
· ED global configuration
· ED curve specific configuration
·Extrapolation
· Concentration
· ED curve data
· Curve fit results
· Maximum curve fit order
(1) Available only if the petroleum
measurement application is installed.
(2) Available only if the enhanced density
application is installed.