Filter
Top Products
94 Micro Motion
®
Model 2400S Transmitters for PROFIBUS-DP
Measurement Performance
Figure 10-3 Meter verification procedure – EDD
Set Stiffness limit set point
(optional)
Enable meter verification =
Normal Enable
Set Output state (optional)
Able to
complete?
Check Abort code
(1)
CAUTION
Yes (>0)
Check
Algorithm state
Running?
Check
Progress (% complete)
Yes (=16)
Check LPO stiffness out
of limits
Within limits? No (>0)
Yes (=0)
Check RPO stiffness out
of limits
Within limits? No (>0)
Yes (=0)
CAUTION
PASS
No (<16)
No (=0)
Manual abort (optional)
Check
State at abort
Device >
Meter Verification
Transfer
(1) See Table D-4, Index 57.