Filter
Top Products
Configuration and Use Manual 73
Optional Configuration
Required Configuration Optional ConfigurationUsing the TransmitterUsing a PROFIBUS Host Required Configuration Optional ConfigurationUsing the TransmitterUsing a PROFIBUS Host Required Configuration Optional ConfigurationUsing the TransmitterUsing a PROFIBUS Host Required Configuration Optional ConfigurationUsing the TransmitterUsing a PROFIBUS Host
To configure fault timeout:
• Using ProLink II, see Figure C-2.
• Using a PROFIBUS host with the EDD, see Figure C-9.
• Using PROFIBUS bus parameters, use the Diagnostic block (see Table D-4), Index 19.
Note: This functionality cannot be configured via the display menus.
8.11 Configuring device settings
The device settings are used to describe the flowmeter components. Table 8-13 lists and defines the
device settings.
To configure device settings using ProLink II, see Figure C-2.
Note: This functionality cannot be configured via the display menus or PROFIBUS protocol.
If you are entering a date, use the left and right arrows at the top of the calendar shown in ProLink II
to select the year and month, then click on a date.
8.12 Configuring PROFIBUS I&M function values
Most I&M function values are configured at the factory and cannot be changed by the user. Two I&M
function values can be configured by the user:
• Device identification tag
• Device location identification tag
To configure these values:
• Using ProLink II, see Figure C-2. ProLink II v2.6 or later is required.
• Using a PROFIBUS host with the EDD, see Figure C-12. You must connect as a Specialist to
use the I&M Functions menu.
• Using PROFIBUS bus parameters, see Table D-9.
Note: These values cannot be configured via the display menus.
Table 8-13 Device settings
Parameter Description
Descriptor Any user-supplied description. Not used in transmitter processing, and not required.
Maximum length: 16 characters.
Message Any user-supplied message. Not used in transmitter processing, and not required.
Maximum length: 32 characters.
Date Any user-selected date. Not used in transmitter processing, and not required.