Filter
Top Products
Configuration and Use Manual 17
Startup Using ProLink IITransmitter User InterfaceBefore You Begin
Chapter 4
Connecting with ProLink II or Pocket ProLink
Software
4.1 Overview
ProLink II is a Windows-based configuration and management tool for Micro Motion transmitters. It
provides complete access to transmitter functions and data. Pocket ProLink is a version of ProLink II
that runs on a Pocket PC.
This chapter provides basic information for connecting ProLink II or Pocket ProLink to your
transmitter. The following topics and procedures are discussed:
• Requirements – see Section 4.2
• Configuration upload/download – see Section 4.3
• Connecting to a Model 2400S DP transmitter – see Section 4.4
The instructions in this manual assume that users are already familiar with ProLink II or
Pocket ProLink software. For more information on using ProLink II, see the ProLink II manual. For
more information on using Pocket ProLink, see the Pocket ProLink manual. Both manuals are
available on the Micro Motion web site (www.micromotion.com). Instructions in this manual will
refer only to ProLink II.
4.2 Requirements
To use ProLink II with the Model 2400S DP transmitter:
• You must have ProLink II v2.5 or higher.
• You must have either the ProLink II installation kit appropriate to your PC and connection
type, or the equivalent equipment. See the ProLink II manual or quick reference guide for
details.
To use Pocket ProLink with the Model 2400S DP transmitter:
• You must have Pocket ProLink v1.3 or higher.
• In addition:
- If you will connect to the transmitter via the service port clips, you must have either the
Pocket ProLink installation kit or the equivalent equipment. See the Pocket ProLink
manual or quick reference guide for details.
- If you will connect via the IrDA port, no additional equipment is required.