Filter
Top Products
Configuration and Use Manual 29
Required Transmitter Configuration
Required Configuration Optional ConfigurationUsing the TransmitterUsing a PROFIBUS Host
Figure 6-3 Configuring measurement units
Density
Temperature
Flow
(1)
Pressure
ProLink >
Configuration
Units
Off-line maint >
Off-line config
Vol (or GSV)
Density
Mass
Temperature
Pressure
Mass flow unit
Temperature unit
Block: Measurement (Slot 1)
Index 5
Density unit
Volume flow unit
(liquid)
Block: Measurement (Slot 1)
Index 7
Block: Measurement (Slot 1)
Index 9
Block: Measurement (Slot 1)
Index 11
Volume flow unit
(GSV)
Block: Measurement (Slot 1)
Index 38
Pressure unit
Block: Calibration (Slot 2)
Index 38
Density
Temperature
Flow
(2)
Pressure
Flow > GSV >
GSV Process Variables
(3)
MMI Coriolis Flow >
Configuration parameters
Display
ProLink II PROFIBUS host with EDD
(1) Used for mass flow, liquid volume flow, and gas standard volume flow.
(2) Used for mass flow and liquid volume flow.
(3) Used for gas standard volume flow.
(4) Set parameters to the desired Unit Code, as listed in Tables 6-2 through 6-7. See Tables D-2 and D-3 if
required.
PROFIBUS host with bus parameters
(4)