Filter
Top Products
20 Micro Motion
®
Model 2400S Transmitters for PROFIBUS-DP
Connecting with ProLink II or Pocket ProLink Software
Figure 4-1 Service port connections to service port clips
3. Start ProLink II or Pocket ProLink software. From the Connection menu, click
Connect to
Device
. In the screen that appears, specify:
•
Protocol: Service Port
• COM Port: as appropriate for your PC
No other parameters are required.
4. Click
Connect. The software will attempt to make the connection.
Note: While you are connected to the IrDA port, both optical switch indicators will flash red, and both
the Scroll and Select optical switches are disabled.
5. If an error message appears:
a. Ensure that you are using the correct COM port.
b. For connections to the IrDA port, ensure that the IrDA port is enabled.
c. For connections to the service port clips, swap the leads between the clips and try again.
d. For connections to the service port clips, check all the wiring between the PC and the
transmitter.
4.5 ProLink II language
ProLink II can be configured for several different languages. To configure the ProLink II language,
use the Tools menu. See Figure C-1.
In this manual, English is used as the ProLink II language.
Service port clips
RS-485 to RS-232
signal converter
25-pin to 9-pin serial port
adapter (if necessary)
RS-485/A
RS-485/B
PC