Reliant PB6001401 Thermometer User Manual


 
Hardware
2-19
Octel Overture 200/300 Serenade 3.0
PB60014–01
Each
LIC contains the necessary circuitry for ring detection, dial tone detection, and signal power
measurement, allowing automatic gain control from 0 dB to 24 dB of gain for recording messages.
The LIC contains a yellow LED for each port, which indicates port activity
.
In the Octel Overture 200, line cards can occupy slots A1 through A6.
In the Octel Overture 300, line cards can occupy slots A1 through A1
1.
Telemarketing Line Card (TLC)
The
telemarketing line card is an 8-port line card. It differs from the LIC, because only the first port
of the TLC located in slot A1 can be used for recording. The seven remaining ports of the TLC in
slot one are play-only ports. All other TLC ports in the message server are play-only ports. When
recording is attempted on other ports, the Octel Overture 200/300 prompts
“Messages may not be
recor
ded at this time. No storage is available.”
The first TLC must be installed in slot A1. Standard line cards can be installed in slots beyond the
TLC cards. The TLC is FCC part 68 registered.
In the Octel Overture 200, the TLC can occupy slots A1 through A6.
In the Octel Overture 300, the TLC can occupy slots A1 through A1
1.
Direct
Access Card (DAC)
The
direct access card (DAC) is an optional, 4-port interface card. When used in place of the standard
LIC, the DAC allows the direct connection of incoming DID or outgoing PBX trunks. The DAC
requires an external –48-Vdc PSU and a rear
-mounted DID I/O panel.
In the Octel Overture 200, the DAC can occupy slots A1 through A6.
In the Octel Overture 300, the DAC can occupy slots A1 through A1
1.
EntryWorks ACP Card
The
EntryW
orks ACP card is the application control processor for the W
orks for Serenade
flow
control language. It includes the host interface and the ACP SCSI disk drive control.
In the Octel Overture 200, the EntryW
orks ACP must occupy slot A7.
In the Octel Overture 300, the EntryW
orks ACP must occupy slot A12.
EntryWorks
also requires the following:
- EntryW
orks disk drive
- EntryWorks
serial I/O panel and cable
- EntryW
orks external modem and cable