Filter
Top Products
9-28
Installation and Maintenance
V
olume
Octel Overture 200/300 Serenade 3.0
PB60014–01
7. Using
a flat-bladed screwdriver
, tighten the two captive screws that are attached to the front flange of
the drive assembly
.
8.
Follow the procedure in the Procedures chapter
, Hard-Disk Restore/Add/Replace section, in this
volume, to restore the message server to correct configuration.
9. T
est the message server for correct operation.
Octel
Overture 300 Floppy-Disk-Drive Replacement
In
the event of damage or a malfunction, an
Octel Overture 300 floppy-disk drive might need to be
replaced.
Only
floppy-disk drives supplied by Octel can be used to replace a drive or to upgrade a message
server
. The disk-drive assembly includes
all necessary
cables.
Do not r
emove or alter any cables on the
drive assembly
.
Figure 9-18 shows the floppy-disk-drive assembly for the Octel Overture 300.
.
For the Octel Overture 200, the power supply and the floppy drive are part of the power supply
unit. If the floppy-disk drive malfunctions, these subassemblies must be replaced as a unit. Refer
to the Power Supply Unit Replacement section in this chapter to replace an
Octel Overture 200
floppy-disk drive.
Figure 9-18
Octel Overture 300 Floppy-Disk-Drive Assembly