Filter
Top Products
Procedures
12-63
Octel Overture 200/300 Serenade 3.0
PB60014–01
To
continue the procedure.
–––– Press Return to continue ––––
FKOUT 05 81 09
SETVAR DIRWRCHK 0
variable = DIRWRCHK, address = 0x2ax7f5, old value = 1,
new value = 0
Are you sure you want to change the value?
To
change the value. The Octel Overture 200/300 displays
HFORM
HFORM deletes all data on the hard disk file system.
Are you sure you want to do this?
To
confirm your selection. When initialization is complete, the Octel
Overture 200/300 prompts
HFORM completed successfully. Disk removed
CRE H:XBOOT.IM 88
.
.
.
Configuration files will be created or re–sized as needed.
Are you sure you want to do this?
To
confirm your selection and create the configuration files.
If no errors were detected, continue with the next step.
.
F:MFGINIT allows F:LOADCODE to be run without doing
F:REST
ORE for those occasions with there is not Release 7
configuration to restore (for example a new system).
Copies software from the floppy diskettes to the hard disk. This step loads
the operating code into the files just created. Y
ou are prompted when to
insert each diskette.
When the operating code is successfully copied, the Octel Overture
200/300 prompts
The Octel Overture 200/300 displays
PLEASE INSERT THE MODELS DISKETTE
*********************************
–––– Press Return to continue ––––
DCOPY F:MODELS H:MODELS
DCOPY F:MODDAT H:MODDAT
21. Press
Enter
22. Enter
Y
23. :Y
Enter
24. :Y
Enter
25. @SUBMIT F:MFGINIT
Enter
Restore
System Software
26. @SUBMIT F:LOADCODE
Enter
27. Insert
the Models Diskette
Enter