Filter
Top Products
Log
Commands — Log, List Trace, Call Detail Record 7-31
Octel Overture 200/300 Serenade 3.0
PB60014–01
- Start
T
ime,
S [YY MM DD HH MM]. T
o display the CDR log from a time after the logical begin
time, enter a specific start time. If no start time is specified, the listing begins with the first record
logged after the logical begin time. At the @ prompt, type
CDR S
Enter
T
o select a particular start time, at the @ prompt, type
CDR S,
followed by the year
, month, day
,
hour
, and minute of the start time. Separate the parts of the date and time with spaces.
@CDR S 97 02 07 08 00
- End
T
ime,
E [YY MM DD HH MM]. T
o display CDR data ending at a specified time other than the
last record currently in the log, enter a specific end time.
@CDR E 97 09 07
You
can specify an end time with or without a start time. If no start time is specified, the CDR log is
displayed from the logical begin time to the end time specified.
Y
ou can add additional filters to the command line to display only specific type and status
information.
- W
rap,
[W]
. Use
W
to display the current wrap status in the log file. If some data in the CDR file has
been overwritten, the Octel Overture 200/300 responds with the following:
LOG FILE WRAPPED
LOG FILE BEGINNING TIME IS MM/DD/YY HH:MM:SS
TIME OF FIRST RECORD IN LOG IS MM/DD/YY HH:MM:SS
. If
the logical begin time is not set, line two in the preceding screen is not displayed.
If the logical begin time is set before the file has been overwritten, the Octel Overture 200/300
responds with the following:
TIME OF FIRST RECORD IN LOG IS MM/DD/YY HH:MM:SS
All
records that were logged between the beginning time and the time of first record are lost. If
W
is
specified,
all other filters are ignored in that command line.