Filter
Top Products
5-2
Installation and Maintenance
Volume
Octel Overture 200/300 Serenade 3.0
PB60014–01
5.2 LISTING
AND CLEARING REPORTS
Information
is collected and stored in various internal tables. The information accumulates until the
report is cleared. Reports can be listed without af
fecting the accumulated data. Once the command to
clear a report is entered, the values are reset to zero and resume accumulating.
Most reports show only the date they are run. At the top of reports 1, 2, 6 and 10 are two dates. The
“from” date and time indicate when the table was last cleared. The “to” date and time indicate when the
report was last printed. It is recommended that reports be listed and cleared on a regular basis. The
reports can display individual values up to 65535.
.
Beginning with Serenade Release 3.0, the following reports can display individual values up to
999,999.
System Performance
Digital Network Performance
Network T
raffic
Digital Network Activity
Disk Usage
Port Statistics
Integration Calling Statistics
System Performance by COS
For a report showing the attributes associated with the COS T
able, SCHEDULE T
able, and all
INFORMATION T
ables defined in the SCHEDULE T
able, refer to the
Configuration
volume, COS
chapter
, Using UPDA
TE chapter, for the
LIST
PROFILE
command.
.
This chapter describes all reports except the DID/E&M T
runk Interface report, which is detailed in
DID/E&M T
runk Interface Installation and Maintenance Manual
. For information about Direct
Access Cards, refer to the
Dir
ect Access Car
d (DAC) Installation and Maintenance Manual.
Listing a Report
Reports
are printed by selecting from the
LIST REPORT
menu. At the prompt @ enter
LIST REPORT,
or
L R
@LR
1. SYSTEM PERFORMANCE.
2. NETWORK TRAFFIC.
3. USER MESSAGE STATISTICS.
4. USER CALLING STATISTICS.
5. DISK USAGE.
6. PORT STATISTICS.
7. MAILBOX USAGE.
8. USER STATUS DETAIL.
9. INTEGRATION CALLING STATISTICS.
10. SYSTEM PERFORMANCE BY COS.
SELECT REPORT TO BE LISTED. (1 – 10, EMPTY LINE = EXIT)
: