Filter
Top Products
DTIC
10-13
Octel Overture 200/300 Serenade 3.0
PB60014–01
Timeslot 16 Signaling Channel Status — state of only this channel
Field
Possible values
Description
RECEIVE
State In
frame
Out of frame
Normal operation.
Can send voice data but not information regarding
call progress, etc.
MF RAI (Multi-Frame
Remote Alarm Indication)
OFF
ON
Far end satisfied with signal on this channel.
Far end not satisfied.
AIS (Alarm Indication
Signal)
OFF
ON
Normal.
Problem with far end sending pattern, cannot make
phone calls.
TRANSMIT
Mode CAS
CAS (Channel Associated Signaling) is the only
mode currently
.
MF RAI (Multi-Frame
Remote Alarm Indication)
OFF
ON
DTIC satisfied with signal being received.
DTIC not satisfied with signal being received.
AIS (Alarm Indication
Signal)
OFF
ON
Normal.
Problem.
CM
State*
State On-line
Off-line
Normal.
Not
functioning. For example, the card may be
of
f-line for 20–30 minutes when the system is
being booted. The card doesn’
t think the system
knows the card is there.
.
When the card is being brought up, the CM
State normally starts off-line for 10 seconds
to 30 minutes, depending on whether the
system software is already up or not.
* Card Manager (CM) is the basic high-level software for the DTIC card.
Both
the card and port status also indicate problems. Following is the status card listing:
dtic>ST CARD
––––– Channel Status – ALL –––––––––––––––––––––––––––––––––––––––––––––––––––––––
CARD STATE: DOWN
SEQUENCER PC: C2
CLOCK MASTER: Disabled
CLOCK ACTIVE: Disabled
The
card status explicitly says that the card is DOWN, although the reason is not given. The reason is
given in the trunk status. Also, the card is not actively configured as a clock master (that is, the status is
“Disabled”) by the system, a consequence of the card being down. The following gives basic information
about the fields for the status of the card.