Filter
Top Products
4-44
Installation and Maintenance
Volume
Octel Overture 200/300 Serenade 3.0
PB60014–01
4.9 SOFTWARE
INST
ALLATION
System
parameters and customer
-provided information are entered in the message-server memory
through a terminal and a two-part configuration program. Use the INST
ALL program to enter
information for new installations; use the UPDA
TE program for verification and to change the
configuration database. This section is an overview of the software installation. Detailed directions for all
steps are found in the
Configuration
volume
.
Using INSTALL — Entering the Configuration Database
After
the operating system has been loaded and the self-test completed, the Octel Overture 200/300 is
ready for you to enter the password. After a valid password is entered, begin the INST
ALL program. At
the @ prompt, type
INSTA
Enter
When prompted, enter data as described in the
Configuration
volume to define the database.
Answer
Y
when the Octel Overture 200/300 asks whether you want to save the configuration to diskette.
Follow the Octel Overture 200/300 directions to insert the configuration diskette in the floppy-disk drive.
Using
UPDA
TE
Use
the UPDA
TE program for verifying and modifying the configuration database, as described in the
following two sections.
Verifying the Configuration Database
After
you finish the message server configuration, the terminal again displays the
@
prompt. T
o get a
printout of the database, enter the UPDA
TE program. At the @ prompt, type
UP
Enter
The terminal displays the dot (.) prompt. At the dot, type
L ALL
Check
the printout with the configuration forms and verify that the data is correct. If correct, exit from
the program by typing
E
If any of the data is incorrect, follow the instructions in the
Configuration
volume when changing the
database. When any changes are made in the configuration database, always save the information on a
diskette when exiting the UPDA
TE program. Answer
Y
when the Octel Overture 200/300 asks whether
you want to save the configuration to diskette.
Modifying the Configuration Database
You
can modify
, add, or delete message-server configuration data. When the terminal or teleprinter
displays the @ prompt, type
UP
and press
Enter
to access the UPDA
TE program. At the dot (.) prompt,
you can enter an UPDA
TE command. Refer to the
Configuration
volume, UPDA
TE T
able chapter
,
Understanding Update section.