Filter
Top Products
8-30
Installation and Maintenance
V
olume
Octel Overture 200/300 Serenade 3.0
PB60014–01
Table 8-2
Hardware Error T
ypes and Remedies (continued)
Error T
ype:Name PriorityRemedySource
64. LAN
Card
Hardwar
e Err
or
(continued)
Problem detected by
the LAN card.
Dependent on the DA
T
A-1 values described
below.
3
DAT
A-2 values in case of LAN_LOST_COMM:
1
Unable to read card status.
2
Card status is nonoperational.
3
CB timed out at start of read reply
.
4
CB timed out during read reply packet.
5
CB time out at start of send request.
6
CB timed out when checked if took request.
7
CB timed out at end of the read reply
.
8
CB timed out during write request packet.
9
CB timed out after write request.
1 0
Complement of replies not match.
1 1
Checksum wrong after control bus copy
.
03 = REACHED THE MAX. RETRY COUNT WHILE SYNCHRONIZING.
FORCED RESET DONE TO SYNCHRONIZE.
The
CPU is unable to communicate with the LAN card.
REMEDY:
Same as for DA
T
A-1 = 02.
04 = LAN CONTROL BLOCK REQUEST SIZE MISMATCH
Compatibility
problem with the LAN card.
REMEDY:
Contact your technical support center
.
05 = LAN CONTROL REPLY BLOCK SIZE MISMATCH
Compatibility
problem with the LAN card.
REMEDY:
Contact your technical support center
.
06 = LAN CONTROL BUS TIME OUT DURING READING/WRITING
CONTROL BUS
Problem
with the LAN card.
REMEDY:
Contact your technical support center
.
07 = OEM NCK OF OTHER SYSTEM DOES NOT MATCH OURS
OEM
type between systems is incompatible.
REMEDY:
Use the
LANSTAT
command to determine which location
is in the OEM-F
AIL state. Check the OEM type of the
current system. Contact your technical support center
.