Filter
Top Products
4-2
Installation and Maintenance
Volume
Octel Overture 200/300 Serenade 3.0
PB60014–01
7. Unlock
and open the front door
. It is recommended that the front door be removed before moving the
cabinet from the pallet.
8.
Lift the cabinet straight up, until the stabilizer legs have cleared the server
. Lift the server off the
pallet toward the pallet opening at the front of the server
.
9.
Place the server in its permanent location.
10.
Replace the front door
.
11.
When the Octel Overture 200/300 is installed, adjust the levelers until the top of the server is level and
does not wobble. No special tools are required to adjust the leveling, although a bubble level is
recommended for this purpose.
12.
Collect and save all packing material, cartons, foam inserts, shipping pallet, etc., as they can be reused
to ship the server back to Octel if any shipping damage was incurred.
Reshipping
If
the Octel Overture 200/300 is to be reshipped from your location, use the original shipping carton, and
perform the following:
1. V
erify that all server assemblies are secure.
a.
All boards must be seated and secured with locking ejectors.
b.
All captive fasteners on the disk drive, power supply
, and fan assemblies must be secured to the
cabinet with a flat-blade screwdriver
.
2.
Remove cabinet front door by opening the door and pulling it straight up, until it is free of the two
hinges.
3.
Remove the front pallet section and place the server on the shipping pallet. This
must
be performed
by two people.
4.
Replace and lock the front door
.
5.
Resecure the front pallet section against the front door
, using two pallet bolts.
6.
Replace the plastic bag over the cabinet.
7.
Secure the cabinet to the pallet using new tie straps.
8.
Replace the door key and power supply cord in the documentation bag and tape the bag to the top of
the cabinet.
9.
Replace the foam insert, then the cardboard container
.
10. T
ape the top of the cardboard carton closed and secure it to the pallet with new strapping material.
Caution!
Do not transport the Octel Overture 200/300 message
server unless it is secured on the shipping pallet in
the vertical, upright position.