Filter
Top Products
System
Errors and T
raf
fic Pegs 8-1
Octel Overture 200/300 Serenade 3.0
PB60014–01
8.1 BOOT
ROM DIAGNOSTICS
When
the Octel Overture
t
200/300 message server is loaded or reloaded (loss of power
, system error
, or
a command), the CPU and the VCU execute a boot ROM diagnostic. The following describes how to
access and interpret the boot ROM errors.
T
urn ON the terminal and set the speed to 300, 1200, or 9600 baud. At any of these speeds, the Octel
Overture 200/300 prints or displays the diagnostic status. Turn ON the power to the cabinet. Press
Enter
repeatedly to establish the baud rate. The complete diagnostic message shown below is printed.
The word
FAILED
is displayed if one of the tests fail.
CPU Model 300–6039–001 Rev 02F
486 Step 27 12MB
Testing Processor...PASSED
Testing System Voltage/Temp...PASSED
Testing ROM Checksum...PASSED
Testing PIT...PASSED
Testing DMA...PASSED
Testing UART...PASSED
Testing Modem...PASSED
Testing TDM Crosspoint...PASSED
Testing Floppy...PASSED
Testing RTC...PASSED
Testing BIC...PASSED
Testing OCC...PASSED
Testing WDT...PASSED
Testing Control Bus Interface...PASSED
Testing COMPLETED
Booting from SCSI file XBOOT.IM
Image loaded
Loading Image from Hard Disk
Loading file VMS1_2.IM
Loading file VMS2_2.IM
Image loaded
–––––––––––––––– SYSTEM SOFTWARE RELEASE SX.X.X–2 (MM/DD/YY) ––––––––––––––––
Copyright 19XX Octel Communications Corp. All Rights Reserved.
THU 04/07 09:51:31 1997 E1–ISDN ID: S/N:000000 PBX:00
(Modem enabled) Last Logon : 00/00 00:00
@WAITING FOR VCU READY
LOADING VCU WITH FILE H:VCU.IM
VCU STARTED
RUNNING DISK REBUILD... REBUILD DONE
INITIALIZING PORTS...
PORT INITIALIZATION DONE
PASSWORD:
@
If
errors are encountered, an error message is printed. If a problem is found, the terminal displays a
specific error number
. T
able 8-1 contains a list of possible error numbers, a description of each error
, and
the most likely cause. When a failed assembly is returned for repair
, the specific error number provides
additional information. When contacting your technical support center
, indicate the boot ROM diagnostic
error number
.