Filter
Top Products
6-16
Installation and Maintenance
Volume
Octel Overture 200/300 Serenade 3.0
PB60014–01
Command Basic Definition
UPINTG UPDATE INTEGRATION
Use
this command to restart the integration cards, which disrupts call processing
for 1 or 2 minutes.
VCU
Use this command to connect to the VCU. It provides detailed drive status, drive
configuration, message header information and status on installed hardware. It
also provides error status reported by the VCU such as hard disk drive read-write
errors. In addition, from this command, you can enter the
L DMAP
command to
get more details about the disk drive.
WPDISK WRITE PROTECT DISK DRIVE
Use
this command to write protect a disk, which prevents any new messages from
being created on that disk. If a message server with one or more drives in a
write-protected condition, a type 34 hardware error is logged.
Refer to
DID/E&M T
runk Interface Installation and Maintenance
manual, Diagnostic and
Administrative Commands section, for the commands used to communicate with the DID/E&M
T
runk Interface Modules. Refer to the
Dir
ect Access Car
d (DAC) Installation and Maintenance
Manual
for information about direct access cards.