Filter
Top Products
Installation
4-55
Octel Overture 200/300 Serenade 3.0
PB60014–01
10. From
telephone A, enter the hunt-group extension number or access code.
11.
Does the Octel Overture 200/300 answer correctly?
YES ' Continue.
NO '
Determine the cause and correct before continuing.
12.
Enter
PS
at the terminal.
13. V
erify that all ports are in the
IDL
state and that the cancel forwarding string (System Parameter 46
— SYSTEM RELOAD CANCEL FOR
W
ARD STRING) is correct. If any ports still show
FWD
, use
TE C 2 x,
where x is the port number
, to cancel forwarding. If cancel forwarding does not work,
determine the cause and correct it before continuing.
Test
to Verify T
runk T
o Octel Overture 200/300 Operation
1.
From the terminal, enter the
PS
command.
2.
Does the port status show all ports in the IDL state?
YES ' Continue.
NO '
Determine the cause and correct the problem before continuing.
3.
From telephone A, call outside the PBX and back in on trunks dedicated to the hunt group.
4.
Does the Octel Overture 200/300 answer correctly?
YES ' Continue.
NO '
Determine the cause and correct the problem before continuing.
5.
From the terminal, enter the
PS
command.
6.
Does the port that answered show
WFD
state?
YES ' Continue.
NO '
Determine the cause and correct the problem before continuing.
7.
From telephone A, enter the extension number associated with telephone C. The Octel Overture
200/300 responds with
“Thank you, just a moment.”
8.
Does telephone C ring?
YES ' Continue.
NO '
Determine the cause and correct the problem before continuing.
9.
Enter the
PS
command. Port status should show port 1 in the AIC (assisted incoming call/automated
attendant) state.
10.
Answer telephone C. Does the Octel Overture 200/300 say
“Beep, beep, beep....Connecting”
and
transfer the incoming trunk to telephone C?
YES ' Continue.
NO '
Determine the cause and correct the problem before continuing.
11.
From the terminal, enter the
PS
command, and verify that the port state is
IDL.
12.
Busy-out the port that answered.