Filter
Top Products
Procedures
12-43
Octel Overture 200/300 Serenade 3.0
PB60014–01
An
explanation of the entries in the display follows.
-
Slot.
Slot number for which status is given. The alphabetic character identifies the Octel Overture 200/300
shelf; the numeric character identifies the slot number
.
Octel Overture 200
Octel
Overture 300
System
1
System 1
System 2 System 2
V
oice 1
V
oice 1
V
oice 2
V
oice 3
V
oice 4
- T
ype.
Identifies the type and sequence of the drive slots, as one of the following:
-
ID.
Identifies the type and sequence of the disk drives, as previously recorded on the drive itself. When
physically installed in the correct slot, the drive appears as
Octel Overture 200
Octel
Overture 300
S1 S1
S2 S2
V1 V1
V2
V3
V4
- Status.
Gives the status of the drive, as one of the following:
Active Valid
Invalid Unknown
Illegal Error
Empty
Refer to the status entry explanations in the
DSKMAP
section of this chapter
.
- Configur
ed.
Identifies the drive as one of the following:
-
Configured — Drive is within the number of drives currently configured.
-
Not Configured — Drive is not being utilized as its position is greater than the number of drives currently
configured.
DISKO
The
DISKO
utility
, available when the Octel Overture 200/300 is booted from floppy software using the Update
diskettes, prepares the message server for
-
Adding a disk
-
Removing a disk
-
Replacing a disk