Filter
Top Products
8-34
Installation and Maintenance
V
olume
Octel Overture 200/300 Serenade 3.0
PB60014–01
Table 8-2
Hardware Error T
ypes and Remedies (continued)
Error T
ype:Name PriorityRemedySource
66. LAN
Card
Reported
Hardwar
e Err
or
(continued)
Problem detected by
the LAN card.
Dependent on the DA
T
A-1 values as
described below
.
3
05 = SNMP MANAGER HOST NAME CANNOT BE RESOLVED
Possible
reasons include:
-
Manager host name may be bad.
-
Name server IP address may be bad.
-
The Octel Overture 200/300 cannot communicate with the name
server.
-
Other — error code in
DATA-2
and
DATA-3
gives more
information.
REMEDY:
Correct the SNMP manager host name.
-
Correct the name server IP address.
-
Configure the SNMP manager IP address.
DATA-2
= 1, 2, or 3. This tells us where the error was logged
from.
DATA-3
and
DATA-4
together give 16 bits of error
information.
06 = BAD_SUBNET
The subnet mask for self is not configured correctly
..
Most common reason is that the subnet mask has never been
configured. The subnet mask is configured for SELF only
, and the
value configured is shown went the
L Loc
command is issued.
REMEDY:
Get the correct IP address from the LAN administrator
and reconfigure the message server
07 = DUP_IPADDR — IP ADDRESS CONFLICT.
There
is another system with the same IP address in the subnetwork
that includes the message server
.
REMEDY:
Get the correct IP address from the LAN administrator
and configure it in the definition of SELF
.
DATA-2 = ERROR DATA
DATA-3 = ERROR DATA
DATA-4 = ERROR DATA
67 Patching
Err
or
Dependent on value in
DATA-4.
Contact your technical support center
. 3
DATA-4 = 01 PARTIAL PATCH DETECTED
02 PATCH AREA ALLOCATION ERROR