Filter
Top Products
12-58
Installation and Maintenance
Volume
Octel Overture 200/300 Serenade 3.0
PB60014–01
Hard Disk Restore
These
procedures provide the steps to restore a message server where the
-
Octel Overture 200/300 is configured as a one-disk system and the hard disk needs replacement.
-
Octel Overture 200/300 is configured as a multiple-disk system and both of the system disks need replacement.
.
When doing the Hard Disk Restore procedures, make sure that the diskettes being used are for the correct
release level.
Action Octel
Overture 200/300 Description and Response
Back
up greetings, names, scripted and sequential messages, and Personal
Distribution List names.
Refer to the Backup and Restore of Greetings, Names, Scripted and
Sequential Messages, Personal Distribution List Names, and Prompts
section in this chapter
.
Hard disks may be hot plugged.
Refer to the Hardware Replacement chapter
, Hard Disk Drive
Replacement section, for Hard Disk Replacement procedures. Hard disks
may be hot plugged.
T
wo floppy diskettes are required to boot the Octel Overture 200/300.
Preparation
Replace
the Hard Disk
1. Forward
ports.
2.
Remove the hard disk(s)
to be replaced.
3.
Install the replacement hard
disk(s).
4.
Make sure software diskettes #1
and #2 (for the correct release
level) are write- protected.
5.
Insert software diskette #1 into
the Floppy Drive (FD).