Filter
Top Products
Installation
4-51
Octel Overture 200/300 Serenade 3.0
PB60014–01
PBX Functional Test
Verify
that each Octel Overture 200/300
port extension can initiate a transfer by doing a hookswitch flash
and a transfer code or just a hookswitch flash, before entering an extension number
. Also, verify that you
can reconnect to the caller when the extension called is not answered or busy
. Perform the following steps:
1.
Connect telephone B to the modular
-adapter position associated with port 1 of the Octel Overture
200/300.
2.
From telephone A, call the extension number associated with telephone B.
3.
Answer telephone B, and perform a hookswitch flash.
4.
Does the PBX provide a stutter or solid dial tone after the hookswitch flash?
YES '
If either tone is present, continue to step 5
NO '
Stop and correct the problem before continuing.
5.
Enter the transfer initiate code, if any
, then enter the extension number associated with telephone C.
6.
After several ringbacks, perform a hookswitch flash and reconnect code, if required, to reconnect to
telephone A.
7.
Did telephone C stop ringing? Were you get reconnected to telephone A, which was on hold?
YES '
Connect telephone B to the next Octel Overture 200/300 port extension and
continue until the extensions for each port are tested.
NO '
Determine the cause and correct the problem before continuing.
8.
Make telephone C busy by taking it of
f-hook. Then repeat the test, starting with step 1 and calling a
busy extension instead of the ring-no-answer extension.
.
The extension number connected to telephone C should start with the same first digit as those
configured in the USER T
able.
Test for Calls to the Intercept Extension (Attendant)
Verify
that each extension can transfer a call to the intercept extension (attendant), as follows:
1.
Connect telephone B to the modular
-adapter position associated with port 1 of the Octel Overture
200/300.
2.
From telephone A, call the extension number associated with telephone B.
3.
Answer telephone B, and perform a hookswitch flash and enter the transfer code, if required. Press
0
(or the attendant’
s extension number), then hang up telephone B.
4.
Did telephone A connect with the operator?
YES '
Continue test for all extensions, then proceed to the test in the next section.
NO '
Determine the cause and correct the problem before continuing.
.
Some PBXs do not allow a blind (unscreened) transfer to an attendant. If this is the case, do
not assign Attribute 15 — TRANSFER T
O A RINGING EXTENSION, to the COS for this
mailbox.