Filter
Top Products
DMA Operations Guide Users
312 Polycom, Inc.
See also:
“Users” on page 294
“Conference Rooms Dialog Box” on page 303
“Add Dial-out Participant Dialog Box” on page 312
“Edit Dial-out Participant Dialog Box” on page 313
“Conference Rooms Procedures” on page 315
Add Dial-out Participant Dialog Box
Lets you add a participant to the conference room’s Dial-out Participants list.
When someone dials into the conference room and starts a conference, the
system dials out to the participants in the list.
The following table describes the parts of the Add Dial-out Participant dialog
box.
Audio-Only
IVR Dial-out
Enables you to link this preset conference to an external
audio conferencing bridge. Requires an RMX MCU with
ISDN service configured.
In the Digits field, specify the E.164 number that the RMX
ISDN service must dial to connect to the audio conferencing
bridge. In the IVR DTMF field, specify any DTMF digits (such
as an access code or PIN) to send to the audio conferencing
bridge after connecting (use p to specify a pause).
Like the dial-outs to participants, this dial-out takes place
when the conference starts.
Note: If no RMX with ISDN service is available in the MCU
pool order used by this conference room, the conference
fails. When the last participant leaves the VMR (that is, when
only participants on the audio conferencing bridge remain),
the link to the audio conferencing bridge is terminated and
the conference ends.
Dial-out
Participants
Lists the names and URIs of the participants to be
automatically dialed when the conference starts.
Click Add to add a participant. Click Edit or Delete to modify
or remove the selected participant.
Table 12-7 Edit Conference Room dialog box (continued)
Field Description
Table 12-8 Add Dial-out Participant dialog box
Field Description
Participant name The name of the participant.
Dial-out URI Dial string used to dial the participant.