Filter
Top Products
DMA Operations Guide MCUs
136 Polycom, Inc.
9 If the MCU is configured as a conferencing resource, optionally change
the MCU pool(s) to which it’s assigned. See “MCU Pools” on page 137.
The pool(s) to which the MCU belongs, and the pool order(s) to which a
pool belongs, are used to determine which MCU is used for a conference.
See “MCU Pool Orders” on page 141.
To delete an MCU
1 On the Dashboard, verify that there are no calls and conferences on the
MCU you want to delete.
2 Go to Network > MCU > MCUs.
3 In the MCUs list, select the MCU you want to remove from the Polycom
DMA system’s pool of available conferencing resources.
4 In the Actions list, select Delete.
5 When asked to confirm that you want to delete the selected MCU, click
Yes.
To immediately stop using one or more MCUs for conferencing and simplified
ISDN dialing
1 Go to Network > MCU > MCUs.
2 In the MCUs list, select the MCUs of interest.
3 In the Actions list, select Stop Using.
4 When asked to confirm that you want to stop using the MCUs, click Yes.
The Polycom DMA system immediately terminates all H.323 calls and
conferences that it placed on those MCUs (for SIP calls only, it migrates the
calls to in-service MCUs with available capacity). It also excludes these
MCUs from consideration for any future conferences and simplified ISDN
dialing calls.
This has no effect on the MCUs themselves, which continue to accept any
calls from other sources.
To stop using one or more MCUs, but allow existing calls and conferences to
continue
1 Go to Network > MCU > MCUs.
2 In the MCUs list, select the MCUs of interest.
3 In the Actions list, select Busy Out.
4 When asked to confirm that you want to busy out the MCUs, click Yes.
The Polycom DMA system stops creating new conferences on those
MCUs, but it allows existing conferences to continue and accepts new calls