Filter
Top Products
3-9
Cisco Broadband Access Center 3.8 Administrator Guide
OL-27172-01
Chapter 3 Configuration Workflows and Checklists
Technology Workflows
To configure the ACS URL of a provisioning group from the administrator user interface:
Step 1 On the primary navigation bar, click Servers > Provisioning Groups.
The Manage Provisioning Groups page appears.
Step 2 Click the identifier link of the correct provisioning group.
The View Provisioning Group Details page appears.
Step 3 In the Provisioning Group Properties area, enter the URL in the ACS URL field.
Note Remember that the URL that you configure overrides the discovered ACS URL.
Step 4 Click Submit.
The provisioning group now contacts Cisco BAC at the URL that you configured.
Configuring Home Provisioning Group Redirection Service on the DPE
Cisco BAC provides redirection to the home provisioning group of a device by having the provisioning
groups communicate among themselves (see Redirecting CPE to Home Provisioning Group, page 14-7).
To enable the home provisioning group redirection feature, you must configure the home provisioning
group redirection service on the DPE.
Table 3-7 identifies the configuration tasks that you must perform to configure the home provisioning
group redirection service on the DPE.
Table 3-7 Home Provisioning Group Redirection Configuration
Procedure Refer to...
1. Configure the DPE to use the interface
identified by the IP address for communication
with other provisioning groups.
If you do not configure the DPE to use this
interface, the DPE always binds to the localhost.
The interface ip x.x.x.x. pg-communication
command described in the Cisco Broadband
Access Center 3.8 DPE CLI Reference.
2. Configure the cwmp-redirect service on the
DPE.
To enable the cwmp-redirect service, enter:
service cwmp-redirect 1 enable true
The service cwmp-redirect 1 enable command
described in the Cisco Broadband Access Center
3.8 DPE CLI Reference
For information on CLI commands used for the cwmp-redirect service, see the Cisco Broadband
Access Center 3.8 DPE CLI Reference.