Filter
Top Products
11-12
Cisco Broadband Access Center 3.8 Administrator Guide
OL-27172-01
Chapter 11 Monitoring Cisco Broadband Access Center
Monitoring Server Status
Notification Timeout : 1000
Notification Recipient Table :
[ Host IP address, Community, UDP Port ]
Access Control Table :
Read Only Communities
bacread
Read Write Communities
bacwrite
Monitoring Server Status
This section describes how you can monitor the performance of the RDU and DPE servers in a Cisco
BAC deployment. These servers are the central RDU server and the DPE servers.
You can check server statistics from the:
• Administrator user interface
• DPE CLI
• RDU and DPE log files using the administrator user interface or the DPE CLI.
Using the Administrator User Interface
To view server statistics available on the administrator user interface:
Step 1 On the Primary Navigation Bar, click the Server tab.
Step 2 The Secondary Navigation Bar displays your options: DPEs, Provisioning Group, RDU.
Click the:
• DPEs tab to monitor all DPEs currently registered in the Cisco BAC database.
• RDU tab to display RDU status and statistics.
Step 3 If you clicked:
• DPEs—The Manage Device Provisioning Engine page appears. Each DPE name on this page is a
link to another page that shows the details for that DPE. Click this link to display the details page.
• RDU—The View Regional Distribution Unit Details page appears.
Using the DPE CLI
You can run the show dpe command to view the status of the DPE server. This command does not
indicate if the DPE is running successfully, only that the process itself is currently executing. However,
when the DPE is running, you can use statistics that this command displays to determine if the DPE is
successfully servicing requests.
You can use the show run command to view the current configuration settings on the DPE.
Example 11-1 show dpe Output
dpe# show dpe