Filter
Top Products
17-11
Cisco Broadband Access Center 3.8 Administrator Guide
OL-27172-01
Chapter 17 Configuring Broadband Access Center
Configuring Defaults
System Defaults
When you click the Systems Defaults link, the System Defaults page (see Figure 17-4) appears.
Figure 17-4 System Defaults Page
Table 17-5 describes all fields and buttons appearing in Figure 17-4.
Table 17-5 Configure System Defaults Page
Field or Button Description
Default Device Type for
Device Detection
Identifies the default device type for a device not previously registered in
the RDU. The options include:
• CWMP
• None
If the device detection extension is unable to identify the device type, the
“default type” (CWMP or None) specifies the device type. If you set the
Default Device Type as None, the device record is not added to the RDU.
Unregistered devices can request the RDU for configurations only if you
have enabled the service cwmp num allow-unknown-cpe option from
the DPE command line interface. Otherwise, a request from an unknown
device is not forwarded to the RDU.
Maximum Troubleshooting
Device Count
Identifies the maximum number of devices that you can troubleshoot at
any one time. The default number is 100.