Filter
Top Products
3-3
Cisco Broadband Access Center 3.8 Administrator Guide
OL-27172-01
Chapter 3 Configuration Workflows and Checklists
Technology Workflows
Technology Workflows
This section describes the tasks that you must perform when configuring Cisco BAC to support specific
technologies; in this case, CWMP. These configuration tasks are performed after configuring Cisco BAC
components.
The CWMP technology workflows described in this section are arranged in a checklist format and
include:
• RDU Configuration Workflow, page 3-3
• DPE Configuration Workflow, page 3-5
RDU Configuration Workflow
Table 3-3 identifies the configuration tasks you must perform to configure the RDU for the CWMP
technology.
10. Verify that the DPE successfully connected to
the RDU and was registered.
Viewing Servers, page 16-22
11. Configure the home provisioning group
redirection service on the DPE
The interface ip x.x.x.x. pg-communication and
service cwmp-redirect 1 enable commands
described in the Cisco Broadband Access Center
3.8 DPE CLI Reference.
Table 3-2 DPE Configuration Checklist (continued)
Procedure Refer to ...
Table 3-3 RDU Configuration Workflow
Procedure Refer to ...
1. Create service profiles by using the Cisco BAC
Class of Service.
Define custom properties referenced in templates
from the administrator user interface. The custom
properties can be referenced in configuration and
firmware rules templates.
For each service, you must:
Configuring Custom Properties, page 17-5
a. Create a configuration template.
Add the configuration template to the RDU
from the administrator user interface.
Adding Files, page 17-17
b. Create a firmware rules template.
–
Add the firmware images to the RDU from the
administrator user interface.
–
Add the firmware rules template to the RDU
from the administrator user interface.
Adding Files, page 17-17