Filter
Top Products
17-27
Cisco Broadband Access Center 3.8 Administrator Guide
OL-27172-01
Chapter 17 Configuring Broadband Access Center
Configuring Lease Query
Table 17-9 identifies the fields shown in the Modify Publishing Plug-Ins page.
Step 4 Enter the required values in the Server, Port, IP Address, User, Password, and Confirm Password fields.
These are all required fields and you must supply this information before proceeding.
Click Submit to make the changes to the selected plug-in, or click Reset to clear all fields on this page.
Configuring Lease Query
Cisco BAC, by default, binds to the IP addresses and ports that are described in the below table.
The wildcard is a special local IP address. It usually means "any" and can only be used for bind
operations.
You can also configure the IP address and port of your choice for lease query communication using the
same properties. For example:
/cnrQuery/clientSocketAddress=10.1.2.3:166
Using this property, the DPE binds to the IP address and the port that you specify.
Table 17-9 Modify Publishing Plug-ins Page
Field or Button Description
Plug-In Identifies publishing plug-in name.
Server Identifies the server name on which the data store resides.
Port Identifies the port number on which the data store resides.
IP Address Identifies the IP address of the server on which the data store resides. This
is usually specified when the server name is not used.
User Identifies the user to allow access to the data stored.
Password Identifies the user’s password which allows access to the data stored.
Confirm Password This is used to confirm the password entered above.
Table 17-10 Modify Publishing Plug-ins Page
Protocol IP Address Port
IPv4 WildCard Any available port