Filter
Top Products
12-14
Cisco Broadband Access Center 3.8 Administrator Guide
OL-27172-01
Chapter 12 Configuring CWMP Service
Connection Request Service
View device log
dpe# show log
dpe# show log last 100
dpe# show log run
Note You can use any of the three
listed commands.
Displays recent DPE log entries.
Displays the last 100 lines of the
DPE log.
Displays the running DPE log.
Example
The output of the show log run command has been shortened for
demonstration purposes.
dpe# show log run
% Press <enter> to stop.
2006 08 04 00:47:01 EDT: %BAC-DPE-6-0104: Obtained configuration
for device [0014BF-CJJ005B00009] from RDU.
2006 08 04 00:47:21 EDT: %BAC-CWMP-6-5129: Device
[0014BF-CJJ005B00009]. Source IP [10.86.147.149]. Retrieving [1]
discovered CPE parameters.
2006 08 04 00:47:21 EDT: %BAC-CWMP-6-5107: Device
[0014BF-CJJ005B00009]. Source IP [10.86.147.149]. Sent
[GetParameterValues] message.
2006 08 04 00:47:21 EDT: %BAC-CWMP-6-5106: Device
[0014BF-CJJ005B00009]. Source IP [10.86.147.149]. Received
[GetParameterValuesResponse] message.
2006 08 04 00:47:21 EDT: %BAC-CWMP-6-5120: Device
[0014BF-CJJ005B00009]. Source IP [10.86.147.149]. New data
discovered from CPE. Queued update of [7] parameters to RDU.
Note Discovery of data is successful if the output of the show log
commands is similar to the sample output featured here.
Table 12-2 Troubleshooting Discovery of Data from DPE (continued)
Task Use ... Description