Filter
Top Products
CHAPTER
12-1
Cisco Broadband Access Center 3.8 Administrator Guide
OL-27172-01
12
Configuring CWMP Service
This chapter describes how to configure the CWMP service in Cisco Broadband Access Center (BAC).
This chapter includes the following sections:
• CWMP Service Configuration, page 12-1
• Connection Request Service, page 12-2
• Provisioning Group Scalability and Failover, page 12-16
CWMP Service Configuration
CWMP is a specification of a set of remote procedure calls (RPCs), for example, GetParameterValues,
SetParameterValues, and so on. These RPCs define the generic mechanism by which Cisco BAC reads
or writes parameters to customer premises equipment (CPE) in order to manage it. These parameters
include:
• Device configuration information
• Status information
• Performance statistics
You can enable or disable CWMP features on the DPE by using the DPE CLI.
Among the features that you can configure on the DPE are:
• HTTP-based Basic or Digest authentication
• Certificate-based authentication
• HTTP over SSL/TLS service settings
• Handling of unknown devices
• Debugging settings
• Session management settings
• CWMP service settings
• HTTP file service settings
For information on how to configure these properties, see the Cisco Broadband Access Center 3.8 DPE
CLI Reference.