Filter
Top Products
3-2
Cisco Broadband Access Center 3.8 Administrator Guide
OL-27172-01
Chapter 3 Configuration Workflows and Checklists
Component Workflows
DPE Checklist
You must perform the tasks described in Table 3-2 after those described in Table 3-1.
Note Items marked with an asterisk (*) are mandatory tasks or procedures.
5. Configure the RDU database backup procedure. Backup and Recovery, page 10-4
6. Configure the RDU SNMP agent. Using the snmpAgentCfgUtil.sh
Tool, page 11-6
Table 3-1 RDU Workflow Checklist (continued)
Procedure Refer to...
Table 3-2 DPE Configuration Checklist
Procedure Refer to ...
1. Configure the system syslog service for use
with Cisco BAC.
Cisco Broadband Access Center 3.8 Installation
Guide.
2. Change the passwords.* The password command described in the Cisco
Broadband Access Center 3.8 DPE CLI Reference.
3. Configure the provisioning interface. The interface ethernet [intf0 | intf1] command
described in the Cisco Broadband Access Center
3.8 DPE CLI Reference.
4. Configure the Cisco BAC shared secret.* The dpe shared-secret command described in the
Cisco Broadband Access Center 3.8 DPE CLI
Reference.
5. Configure the DPE to connect to the desired
RDU.*
The dpe rdu-server command described in the
Cisco Broadband Access Center 3.8 DPE CLI
Reference.
6. Configure the network time protocol (NTP). Solaris or Linux documentation for configuration
information.
7. Configure the provisioning group name.* The dpe provisioning-group primary command
described in the Cisco Broadband Access Center
3.8 DPE CLI Reference.
8. Configure the required routes to the RDU as
well as to the devices in the network.
Solaris or Linux documentation for configuration
information.
9. Configure the DPE SNMP agent. The SNMP agent commands in the Cisco
Broadband Access Center 3.8 DPE CLI Reference.
Note You can configure the SNMP agent using either the DPE command line interface or the
snmpAgentCfgUtil.sh tool. For more information, see Using the snmpAgentCfgUtil.sh Tool,
page 11-6.