Filter
Top Products
20-3
Cisco Broadband Access Center 3.8 Administrator Guide
OL-27172-01
Chapter 20 Cisco BAC Support Tools and Advanced Concepts
Using the deviceExport.sh Tool
<CONTROLFILE>
<!--Start of field list(REQUIRED)
The field list specifies the device properties that will be exported.
All supported standard fields are listed below. Remove unwanted
fields by deleting the line that contains the field name. Customer
defined properties are not listed but can be added to the list.
-->
<FIELDLIST>
<FIELD>GenericObjectKeys.OID_REVISION_NUMBER</FIELD>
<FIELD>DeviceDetailsKeys.DEVICE_TYPE</FIELD>
<FIELD>DeviceDetailsKeys.OWNER_ID</FIELD>
<FIELD>DeviceDetailsKeys.NODE_DETAILS</FIELD>
<FIELD>DeviceDetailsKeys.DEVICE_ID</FIELD>
<FIELD>DeviceDetailsKeys.FQDN</FIELD>
<FIELD>DeviceDetailsKeys.HOST</FIELD>
<FIELD>DeviceDetailsKeys.DOMAIN</FIELD>
<FIELD>DeviceDetailsKeys.IS_IN_REQUIRED_PROV_GROUP</FIELD>
<FIELD>DeviceDetailsKeys.IS_REGISTERED</FIELD>
<FIELD>DeviceDetailsKeys.IS_PROVISIONED</FIELD>
<FIELD>DeviceDetailsKeys.PROV_GROUP</FIELD>
<FIELD>DeviceDetailsKeys.CLASS_OF_SERVICE</FIELD>
<FIELD>DeviceDetailsKeys.CLASS_OF_SERVICE_SELECTED</FIELD>
<FIELD>DeviceDetailsKeys.PROPERTIES</FIELD>
<FIELD>DeviceDetailsKeys.PROPERTIES_DETECTED</FIELD>
<FIELD>DeviceDetailsKeys.PROPERTIES_SELECTED</FIELD>
<FIELD>DeviceDetailsKeys.REASON</FIELD>
<FIELD>DeviceDetailsKeys.EXPLANATION</FIELD>
<FIELD>DeviceDetailsKeys.CONFIGURATION_REVISION</FIELD>
<FIELD>DeviceDetailsKeys.FIRMWARE_CONFIGURATION_REVISION</FIELD>
<FIELD>DeviceDetailsKeys.REPORTED_IP_ADDRESS</FIELD>
<FIELD>DeviceDetailsKeys.SOURCE_IP_ADDRESS</FIELD>
<FIELD>DeviceDetailsKeys.ROUTABLE_IP_ADDRESS</FIELD>
<FIELD>DeviceDetailsKeys.DEVICE_FAULTS</FIELD>
<FIELD>DeviceDetailsKeys.PENDING_ON_CONNECT_OPERATION_IDS</FIELD>
<FIELD>DeviceDetailsKeys.PASSWORD_IS_PROTECTED</FIELD>
<FIELD>IPDeviceKeys.HOME_PROV_GROUP</FIELD>
<FIELD>IPDeviceKeys.CPE_PASSWORD</FIELD>
<FIELD>IPDeviceKeys.CONNECTION_REQUEST_USERNAME</FIELD>
<FIELD>IPDeviceKeys.CONNECTION_REQUEST_PASSWORD</FIELD>
</FIELDLIST>
<!--End of field list-->
</CONTROLFILE>
Note The DOCTYPE CONTROLFILE SYSTEM references a .dtd file, device-export-control.dtd, which is used for
XML validation. The file is installed in the BPR_HOME/rdu/bin directory.
Example 20-3 Exporting Data from Backup Snapshot
This is an example of exporting data from a backup snapshot:
# ./deviceExport.sh control.xml rdu-backup-20061227-145538 /data/rduexport
Starting exporting devices...
Using backup database in /tmp/rdu-backup-20061227-145538
Device export finished in 28m11s.
Note The exported file is generated in the specified directory; in the above example, in the
/data/rduexport directory. You do not need to specify the full path to the directory.